What it means
Wire installation fail on a Dacor Transitional 36-inch range means the power cord is installed improperly. Cut power at the breaker and book a visit; the cord belongs on the terminal block only for a qualified installer.
Dacor oven Wire installation fail / Installation
Wire installation fail on a Dacor Transitional 36-inch range means the power cord is installed improperly. Cut power at the breaker and book a visit; the cord belongs on the terminal block only for a qualified installer.
Also shown as Wire installation fail
Wire installation fail on a Dacor Transitional 36-inch range means the power cord is installed improperly. Cut power at the breaker and book a visit; the cord belongs on the terminal block only for a qualified installer.
Switch off the breaker for the range before anyone touches the cord or the terminal block.
The message appears after installation, a move, or any work on the supply cord.
Your Dacor tick-list / held on this device

Switch off the breaker for the range before anyone touches the cord or the terminal block.

The manual says each line of the 3-wire or 4-wire cord must be hooked up to the terminal block correctly. That is an installer job.

Note any recent installation, move or cord work.

We reconnect the cord to the terminal block, then restore power.
Tell us the model and which checks you have done, then open your request from here.
Book a visit
This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
The power cord is installed improperly. The oven detected a wrong connection.
Read the supporting manualMake sure each line of the 3-wire or 4-wire cord is hooked up to the terminal block correctly, then reconnect the power. If that does not solve it, call for service.
Read the supporting manualNo. Do not use the range with a wrongly connected cord.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DG68-01105E-00, 2020-07-06 (EN+ES+FR) / PDF p.55 (Troubleshooting, Information codes, right column)
Printed only in the Transitional 36-inch dual-fuel range guide DOP36P86DL* (DG68-01105E-00, p.55).
The manual describes the correct connection but this is electrical work; use a qualified installer.
No. It is an installation message that appears when the power cord is connected improperly, not a failed part.
It depends on your home wiring and the range cord. The installer decides and checks each line on the terminal block.
Right away, and keep the breaker off until a qualified person has checked the cord connection.
Dacor codes, symptoms, parts, repairs
The Heritage wall oven manual lists three owner causes for an oven that will not heat: a wrong temperature setting, a delayed start left on, and a meat probe still plugged in when you broil. Check those in that order, then look at the display for a C- code.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.