FL / Our office
Tampa Bay
100 N Tampa St, Ste 140Tampa, FL 33602
Find your service area
Locate your metro, explain how to reach the appliance, and the visit is confirmed with you.

Our offices
Tap a pin on the map or read down the list of addresses. These are our team offices, while the work itself takes place in your home.
FL / Our office
FL / Our office
FL / Our office
NY / Our office
TX / Our office
IL / Our office
CA / Our office
CA / Our office
CA / Our office
How the visit goes.
Clear steps, start to finish.

Choose the appliance and share the code or symptom. Mention whether yours is a Modernist or a Transitional model.

The technician traces the issue, explains it in plain terms and agrees the cost with you before any repair begins.

Once the repair is done, the technician checks the result with you and explains what was replaced.
Building offices commonly want trade paperwork a day ahead. Call the front desk soon.
A checkpoint can hold a van for minutes. Keep the visitor list current.
Collins Avenue and Brickell buildings often route trades through one entrance. Leave time to sign in.











The technician describes the repair and agrees the cost with you before starting. We confirm the final figure once the oven, range or cooktop has been inspected.
Dacor handles repairs that its manufacturer warranty covers. We provide a warranty of our own on the work we do.
Nine areas, three of them in Florida: Tampa Bay, Orlando and the southeast. The others are New York, Houston, Chicagoland, then San Diego, Los Angeles and the Bay Area.
Not by itself. The office address shows where staff sit rather than where we go. Send the appliance's address and we check whether we can get there.
Gates, stairs, parking and lifts shape how a technician gets to a built-in unit. Every metro page lists the local points to mention.
Any hour works, since the form stays open. Phones and visits wind down at eight in the evening, and our reply follows with details.
Dacor codes, symptoms, parts, repairs
The Heritage wall oven manual lists three owner causes for an oven that will not heat: a wrong temperature setting, a delayed start left on, and a meat probe still plugged in when you broil. Check those in that order, then look at the display for a C- code.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.