Inside the appliance
Hood strip LED light. In plain English.
The Dacor Pro-Canopy and chimney hoods light the cooktop with a strip LED. The Light button cycles it from high to dimmer to off. The guide says only a service technician replaces the strip LED, so a dark light with a working control panel and fan points to a burned-out strip.

Where it fits.
Hood strip LED light in the appliance
A strip LED runs under the hood canopy. The guide shows the Light button on the hood control panel.
The photo shows the type of component. It cannot tell you which replacement fits your model.
What you notice when this system wants attention.
A Hood strip LED light concern can arrive with weaker performance or a code that returns. The component is only blamed after testing.

Dacor Pro-Canopy hood dead or lights out
When a Dacor Pro-Canopy hood does nothing, the chart separates three cases by what still works: nothing at all, lights dead with a working fan, and a fan that is dead while the panel and lights work.

Dacor hood not drawing smoke well
A Dacor hood that is not drawing heat and smoke properly has three listed causes: the fan speed is too low, the filters are clogged, or the damper is stuck shut or the ducting is blocked.
Owner care, within the model instructions.
Turn off and unplug the appliance before any check you can make yourself. Beware of pooled water and sharp fragments. Never touch a wet plug or live wiring, take off service panels, or go beyond what your model's guide allows.
- 1
Press the Light button
First press is high, second is dimmer and third turns the lights off. Try all three before deciding the strip is dead.
- 2
Check the sounds setting
Holding the Light button for 3 seconds turns the control sounds off, which is not a lighting problem.
- 3
Note what still works
If the panel is lit and the fan runs but the lights stay dark, the guide lists a burned-out strip LED. If nothing works, check the main power and breaker.
- 4
Let it cool before cleaning
The guide asks you to let the whole hood, filters and strip LED cool and the grease solidify before cleaning.
Cleaning or replacement?
Leave internal testing to a technician.
Schedule service when the control panel is lit and the fan works but the light stays dark.
Schedule service when the light flickers or one end of the strip is dark.
Schedule service when the hood has no power at all after you have checked the breaker.
Arrange a diagnosticSources and model boundaries.
The Hood strip LED light guidance is built on these references. Choose the manual for your own model.
- Use and Care, Pro-Canopy Wall Hood DHD**U990C*/DA, Chimney Wall Hood DHD**U990W*/DA, Chimney Island Hood DHD**U990I*/DA
Rely on the guide for your precise model. Look at how we research these pages.
Can I replace the hood light myself?
No. The guide says the strip LED is replaceable by a service technician only.
How do I dim the hood light?
Press the Light button. The first press gives high, the second a dimmer setting, and the third switches the lights off.
Why does the hood light not come on when the fan runs?
The troubleshooting table lists a burned-out strip LED when the control panel is lit and the fan works. It tells you to call for service.
How do I silence the hood beeps?
Press and hold the Light button for 3 seconds to turn the control sounds off. That does not affect the lights.
Dacor codes, symptoms, parts, repairs
Link the message to what you do next.
Dacor Pro-Canopy hood dead or lights out
When a Dacor Pro-Canopy hood does nothing, the chart separates three cases by what still works: nothing at all, lights dead with a working fan, and a fan that is dead while the panel and lights work.
Hood repair
Book a diagnostic for your model at the appliance itself.
Find your metro
Office details and the access notes to pass on.

