What it means
The Timer LED on this Dacor hood blinks for five seconds when the countdown reaches zero, and then the hood switches itself off. Press Timer again for another run of up to 99 minutes.
Dacor hood Timer LED blinking / Mode, not a failure
The Timer LED on this Dacor hood blinks for five seconds when the countdown reaches zero, and then the hood switches itself off. Press Timer again for another run of up to 99 minutes.
Also shown as Timer LED blinking
The Timer LED on this Dacor hood blinks for five seconds when the countdown reaches zero, and then the hood switches itself off. Press Timer again for another run of up to 99 minutes.
The blink is the countdown ending.
The Timer LED blinks but the hood keeps running.
Your Dacor tick-list / held on this device

The blink is the countdown ending. The hood turns off on its own right after.

Each press of Timer adds 10 minutes, up to 99, and the hood stays on for the time you set.

Hold the Timer button for three seconds to switch the timer function off.
Auto heat-sensing raises and lowers the fan with the cooktop heat, with no timer needed.
Tell us the model and which checks you have done, then open your request from here.
Book a visit
This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
After the timer counts down to zero. It blinks for 5 seconds.
Read the supporting manualThe hood turns off automatically, so there is nothing to press.
Read the supporting manualPress Timer once for each 10 minutes you want, to a maximum of 99 minutes. The hood stays on for that long.
Read the supporting manualHold the Timer button for three seconds.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
no edition code in the cached text / PDF p.7
Timer control as described in the same use and care guide for these canopy and chimney hoods.
If the Timer had counted down, the LED blinks five seconds and the hood stops. That is the timer function working.
Ninety-nine minutes, in steps of 10 per press.
No. Auto follows cooktop heat; the timer simply runs the hood for a set time.
No. It marks the end of the run.
Dacor codes, symptoms, parts, repairs
A blinking Low button on this Dacor hood is the filter alarm. It comes after every 50 hours of fan use as a nudge to clean the filters. Hold Power for three seconds once they are clean.
When a Dacor Pro-Canopy hood does nothing, the chart separates three cases by what still works: nothing at all, lights dead with a working fan, and a fan that is dead while the panel and lights work.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.