Read the whole display
Say which light is blinking (Low, Timer or Bluetooth), whether the hood is running, and give the model number.
Model-specific code library
Three blinking signals are decoded for the Pro-Canopy and chimney wall hoods: the Low button as the filter alarm, the Timer LED at the end of a countdown, and the Bluetooth icon during pairing. None of them is an error code.
A blinking Bluetooth icon on this Dacor hood means pairing mode is running, started by a three-second hold on ConnectOn. Press the Bluetooth button on the cooktop; when pairing finishes the light stays steady.
Read the Bluetooth icon blinking checks3 researched hood codes. A display message can mean something different on each model, so the manual for yours has the last word.
A blinking Bluetooth icon on this Dacor hood means pairing mode is running, started by a three-second hold on ConnectOn. Press the Bluetooth button on the cooktop; when pairing finishes the light stays steady.
NormalA blinking Low button on this Dacor hood is the filter alarm. It comes after every 50 hours of fan use as a nudge to clean the filters. Hold Power for three seconds once they are clean.
Clean the filtersThe Timer LED on this Dacor hood blinks for five seconds when the countdown reaches zero, and then the hood switches itself off. Press Timer again for another run of up to 99 minutes.
Normal
Three blinking signals are decoded for the Pro-Canopy and chimney wall hoods: the Low button as the filter alarm, the Timer LED at the end of a countdown, and the Bluetooth icon during pairing. None of them is an error code.
The hood guide prints no error table, so there are no letter or number codes to decode. We read one use and care guide for the Pro-Canopy and chimney wall hoods; other Dacor hoods may signal differently.
Say which light is blinking (Low, Timer or Bluetooth), whether the hood is running, and give the model number.
Switch the hood off at the wall before you lift filters out, and let them cool after cooking. The blower and its wiring are for a technician.
When a Dacor Pro-Canopy hood does nothing, the chart separates three cases by what still works: nothing at all, lights dead with a working fan, and a fan that is dead while the panel and lights work.
A Dacor hood that is not drawing heat and smoke properly has three listed causes: the fan speed is too low, the filters are clogged, or the damper is stuck shut or the ducting is blocked.
Rely on the guide for your precise model. Look at how we research these pages.
The hood guide prints no error table, so there are no letter or number codes to decode. We read one use and care guide for the Pro-Canopy and chimney wall hoods; other Dacor hoods may signal differently.
Take a photo of the entire hood panel and one of the rating label. Write down what the appliance was doing when the message came up, and never lean on another product's explanation.
An old search phrase counts for nothing next to the manufacturer's own words. If a hood document gives no decoding, the message appears under its name with no part or cause guessed at.
Open any manufacturer document in this hood library, then match the model on its cover to the label on your appliance. A different model has its own guide.