What it means
Pump operation check is the printed meaning of 3C for the Dacor DDW24G9000AP. Turn the dishwasher off and restart it. If the issue continues, book a visit; the manual lists no other owner step.
Dacor dishwasher 3C / Pump
Pump operation check is the printed meaning of 3C for the Dacor DDW24G9000AP. Turn the dishwasher off and restart it. If the issue continues, book a visit; the manual lists no other owner step.
Also shown as 3C
Pump operation check is the printed meaning of 3C for the Dacor DDW24G9000AP. Turn the dishwasher off and restart it. If the issue continues, book a visit; the manual lists no other owner step.
Switch it off at the control panel and wait a moment.
3C returns after the restart.
Your Dacor tick-list / held on this device

Switch it off at the control panel and wait a moment.

Turn it back on and start a cycle to see whether 3C returns.

If water stays in the tub, drain hose and filter checks from 5C may be relevant. Do not reach in while the power is on.

The pump and its circuit need a technician. Tell us 3C and what the dishwasher was doing.
Tell us the model and which checks you have done, then open your request from here.
Book a visit
This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
The manual calls it a pump operation check. It describes the action as a functional check: turn off the dishwasher and restart.
Read the supporting manualNot by that wording. The drain check is 5C. 3C refers to pump operation, which could be either circulation or drain, and the manual does not say.
Read the supporting manualThe manual says to contact a service center, and we offer a visit instead. Keep the dishwasher off between attempts.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DD68-00250L-00 (DW8700B), 2024-01-11 / PDF p.74
For 3C: the Dacor built-in dishwasher DDW24G9000AP. Source is the information codes table and the dishwasher troubleshooting and installation chapters of its user manual; other Dacor dishwashers are not covered.
No. 5C is the drain check with a hose and pump drain hole to inspect. 3C is the pump operation check with a restart only.
The manual only says to turn off and restart. A longer power cut is not described.
The manual says nothing on that. A cycle that stops may leave dishes unwashed.
Book a visit when 3C returns after the restart. The manual lists no other owner step for the pump operation check.
Dacor codes, symptoms, parts, repairs
A drain problem is what the DDW24G9000AP reports with 5C. Shut the water supply valve, then check whether the drain hose is clogged or folded and whether the drain hole inside the pump is clogged. A technician visit is next if it continues.
On a Dacor DDW24G9000AP, the manual lists a door not fully latched, the upper rack not joined to its duct nozzle, Start (Reset) not pressed, no cycle chosen, an unplugged cord, and a closed water valve. Run those six checks before calling.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.