What it means
The DDW24G9000AP uses HC for a high temperature heating check. With the dishwasher empty, add detergent and run a cycle. If it persists, switch the dishwasher breaker off and book a visit.
Dacor dishwasher HC / Heating
The DDW24G9000AP uses HC for a high temperature heating check. With the dishwasher empty, add detergent and run a cycle. If it persists, switch the dishwasher breaker off and book a visit.
Also shown as HC
The DDW24G9000AP uses HC for a high temperature heating check. With the dishwasher empty, add detergent and run a cycle. If it persists, switch the dishwasher breaker off and book a visit.
Take out all dishes so the test cycle runs with an empty tub.
HC returns on the empty test cycle.
Your Dacor tick-list / held on this device

Take out all dishes so the test cycle runs with an empty tub.

Add dishwasher detergent and start a cycle, as the manual instructs.

If HC does not return, the check passed. If it returns on the test cycle, move on.

If HC persists, set the dishwasher breaker off at your panel and book a visit.
Tell us the model and which checks you have done, then open your request from here.
Book a visitThis drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
The dishwasher detected a high temperature during heating. The manual calls it a high temperature heating check.
Read the supporting manualTo test the heating on a clean tub with detergent. It shows whether the code was a one-off or a repeat.
Read the supporting manual9C9 is an overheating module, with only an unplug instruction. HC is a heating temperature check with a trial cycle first.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DD68-00250L-00 (DW8700B), 2024-01-11 / PDF p.74
For HC: the Dacor built-in dishwasher DDW24G9000AP. Source is the information codes table and the dishwasher troubleshooting and installation chapters of its user manual; other Dacor dishwashers are not covered.
The manual treats it as a check with a test cycle. If it persists, it tells you to cut power at the breaker.
Dishwasher detergent, as the manual says for other checks too.
The manual asks for an empty tub for the test, so remove them first.
Book a visit when HC returns on the empty test cycle, and switch the dishwasher breaker off until we arrive.
Dacor codes, symptoms, parts, repairs
Overheating of the IPM is reported as 9C9 by the DDW24G9000AP. The manual prints one action: unplug the appliance. The dishwasher is built in, so switch its breaker off if you cannot reach the plug, then book a visit.
On a Dacor DDW24G9000AP, the manual lists a door not fully latched, the upper rack not joined to its duct nozzle, Start (Reset) not pressed, no cycle chosen, an unplugged cord, and a closed water valve. Run those six checks before calling.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.