What it means
Overheating of the IPM is reported as 9C9 by the DDW24G9000AP. The manual prints one action: unplug the appliance. The dishwasher is built in, so switch its breaker off if you cannot reach the plug, then book a visit.
Dacor dishwasher 9C9 / Overheating
Overheating of the IPM is reported as 9C9 by the DDW24G9000AP. The manual prints one action: unplug the appliance. The dishwasher is built in, so switch its breaker off if you cannot reach the plug, then book a visit.
Also shown as 9C9
Overheating of the IPM is reported as 9C9 by the DDW24G9000AP. The manual prints one action: unplug the appliance. The dishwasher is built in, so switch its breaker off if you cannot reach the plug, then book a visit.
Overheating electronics can be a fire risk.
9C9 shows.
Your Dacor tick-list / held on this device

Switch the dishwasher off. Since it is built in, switch the dishwasher breaker off at your panel if the plug is out of reach.

Leave it off for a while before opening the door, because hot water and steam can scald.

The manual gives no owner fix for 9C9 beyond unplugging, so do not test it.

The IPM is an electronic power module and needs a technician. Tell us 9C9.
Tell us the model and which checks you have done, then open your request from here.
Book a visitThis drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
The manual says the IPM is overheating. An IPM is an intelligent power module, part of the motor control electronics.
Read the supporting manualIt is the only action printed. Cutting power protects the electronics while the module is hot.
Read the supporting manualHC is a high temperature heating check with a cycle to try. 9C9 is the module overheating, with no test cycle suggested.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DD68-00250L-00 (DW8700B), 2024-01-11 / PDF p.75 (Information codes)
For 9C9: the Dacor built-in dishwasher DDW24G9000AP. Source is the information codes table and the dishwasher troubleshooting and installation chapters of its user manual; other Dacor dishwashers are not covered.
The manual does not offer that for 9C9. Book a visit rather than testing it.
A power module inside the dishwasher that drives a motor. The manual does not describe it further.
The manual does not say, but it tells you to unplug, which is the cautious response.
The code 9C9, the cycle running when it appeared and the model.
Dacor codes, symptoms, parts, repairs
The DDW24G9000AP uses HC for a high temperature heating check. With the dishwasher empty, add detergent and run a cycle. If it persists, switch the dishwasher breaker off and book a visit.
On a Dacor DDW24G9000AP, the manual lists a door not fully latched, the upper rack not joined to its duct nozzle, Start (Reset) not pressed, no cycle chosen, an unplugged cord, and a closed water valve. Run those six checks before calling.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.