What it means
AP is no error on the DDW24G9000AP; it is a pairing prompt. Press and hold Smart Control on the control panel to connect the dishwasher with your smartphone. Ignore it if you do not use the app.
Dacor dishwasher AP / Wi-Fi pairing
AP is no error on the DDW24G9000AP; it is a pairing prompt. Press and hold Smart Control on the control panel to connect the dishwasher with your smartphone. Ignore it if you do not use the app.
Also shown as AP
AP is no error on the DDW24G9000AP; it is a pairing prompt. Press and hold Smart Control on the control panel to connect the dishwasher with your smartphone. Ignore it if you do not use the app.
It is not an error code.
The dishwasher also stops working while AP shows.
Your Dacor tick-list / held on this device

It is not an error code. The dishwasher is asking whether you want to connect to a phone.

Press and hold Smart Control on the control panel, as the manual says.

Open the Dacor app on your phone and follow its steps.

If you do not want to pair, choose a cycle as usual.
Tell us the model and which checks you have done, then open your request from here.
Book a visitThis drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
AP is a prompt to connect with a smartphone. The manual lists it in the information codes table, but as a connection prompt.
Read the supporting manualPress and hold Smart Control on the panel, then use the app. The manual gives no further steps in that entry.
Read the supporting manualNo. If the dishwasher also stops working while AP shows, something else is wrong, so book a visit.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DD68-00250L-00 (DW8700B), 2024-01-11 / PDF p.75
For AP: the Dacor built-in dishwasher DDW24G9000AP. Source is the information codes table and the dishwasher troubleshooting and installation chapters of its user manual; other Dacor dishwashers are not covered.
No. AP is a prompt to pair the dishwasher with a smartphone, and the manual lists it with the information codes only for that reason.
No. The dishwasher runs its cycles from its own control panel, and AP can be ignored if you do not want a phone connection.
The manual says the control panel displays AP for pairing.
Book a visit if AP shows and the dishwasher also refuses to run a cycle, since the pairing prompt alone should not stop it.
Dacor codes, symptoms, parts, repairs
Leakage check is the meaning of LC on this Dacor dishwasher, the DDW24G9000AP. Shut the water supply valve and set the dishwasher breaker to off. Do not run it again until the leak is dealt with; the manual refers the repair to the installer.
On a Dacor DDW24G9000AP, the manual lists a door not fully latched, the upper rack not joined to its duct nozzle, Start (Reset) not pressed, no cycle chosen, an unplugged cord, and a closed water valve. Run those six checks before calling.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.