What it means
C-21 on a Dacor oven means the internal temperature rose abnormally high. Power the oven down and give it time to cool. The 30-inch Transitional guide then says to restart; the other guides share the longer reset ladder.
Dacor oven C-21 / Overheat
C-21 on a Dacor oven means the internal temperature rose abnormally high. Power the oven down and give it time to cool. The 30-inch Transitional guide then says to restart; the other guides share the longer reset ladder.
Also shown as C-21
C-21 on a Dacor oven means the internal temperature rose abnormally high. Power the oven down and give it time to cool. The 30-inch Transitional guide then says to restart; the other guides share the longer reset ladder.
Switch the oven off and leave the door closed unless the oven is smoking.
C-21 returns after cooling and a restart.
Your Dacor tick-list / held on this device

Switch the oven off and leave the door closed unless the oven is smoking. Do not open it while it is dangerously hot.

Wait for the cavity to cool well below baking temperature before touching anything.

On the Transitional 30-inch the printed solution is simply to restart the appliance. On the Modernist wall oven, press OFF and restart.

Where the guide prints the longer ladder, disconnect all power for at least 30 seconds and reconnect, then call for service if it persists.
Tell us the model and which checks you have done, then open your request from here.
Book a visit
This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
The oven sensed an abnormally high internal temperature. It is a protective code.
Read the supporting manualThe wording of the solution cell differs between guides. The 30-inch Transitional says restart the appliance. The Modernist wall oven shares the sensor ladder: press OFF, restart, cut power 30 seconds, then call for service.
Read the supporting manualNo. Let the oven cool and check for obvious causes like a blocked vent. If C-21 returns, book a visit.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 112177 Rev B / DG68-00920A-00 / p.64 (Abnormally high internal temp)
Manufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DG68-01458A-00, 2023-01-17 (EN+ES+FR) / p.102 (own solution: restart the appliance)
Manufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DG68-01105E-00, 2020-07-06 (EN+ES+FR) / p.55 (shared cell)
Manufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 115113 Rev A / p.71 (restart appliance)
Printed in four guides, with a different printed solution in each. Do not apply one universal step.
No. C-31 is an abnormally high PCB temperature, in the control board. C-21 is the oven cavity running hot.
Foil can block vents. The C-24 entry names a blocked vent on the Transitional ranges, though C-21 does not list a cause.
The guides give no time. Wait until the oven is cool to the touch outside and the display clears.
Book a visit when C-21 returns after the oven has cooled and you have restarted it, since the sensing or the heating control may have a problem.
Dacor codes, symptoms, parts, repairs
C-31 on a Dacor oven means the PCB temperature rose abnormally high. The only action printed is to call for service, so turn the oven off and book a visit.
The Heritage wall oven manual lists three owner causes for an oven that will not heat: a wrong temperature setting, a delayed start left on, and a meat probe still plugged in when you broil. Check those in that order, then look at the display for a C- code.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.