What it means
C-31 on a Dacor oven means the PCB temperature rose abnormally high. The only action printed is to call for service, so turn the oven off and book a visit.
Dacor oven C-31 / Control board temperature
C-31 on a Dacor oven means the PCB temperature rose abnormally high. The only action printed is to call for service, so turn the oven off and book a visit.
Also shown as C-31
C-31 on a Dacor oven means the PCB temperature rose abnormally high. The only action printed is to call for service, so turn the oven off and book a visit.
Switch the oven off at the controls and let it cool before you do anything else.
C-31 shows at all.
Your Dacor tick-list / held on this device

Switch the oven off at the controls and let it cool before you do anything else.

The guides print no owner reset, so do not keep restarting it.

Make sure nothing blocks airflow around a built-in unit. This is our general advice, not a manual step.

Give us the code C-31 and the model number when you book so the visit can be planned.
Tell us the model and which checks you have done, then open your request from here.
Book a visit
This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
The circuit board temperature is abnormally high. It is a protective code for the electronics.
Read the supporting manualC-21 is the oven cavity running hot. C-31 is the board running hot.
Read the supporting manualC-A2 is the cooling motor code. The guides do not link C-31 to it, so a technician should check both.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 112177 Rev B / DG68-00920A-00 / p.64 (Abnormally high PCB temp)
Manufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DG68-01458A-00, 2023-01-17 (EN+ES+FR) / p.103
Manufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DG68-01105E-00, 2020-07-06 (EN+ES+FR) / p.55
Manufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 115113 Rev A / p.71 (Occurs if PCB temp is unusually high)
Printed in all four guides with call for service as the only action.
The guides print no reset for C-31. The only printed action is to call for service, so switch the oven off and book a visit.
The guides give no warning, but an overheating board is a reason to switch the oven off at the breaker.
No. C-30 is the PCB sensor open or short, with a restart and power reset. C-31 is the board temperature rising abnormally high.
The code, the model and what the oven was doing when C-31 appeared, such as a long bake or self-clean.
Dacor codes, symptoms, parts, repairs
C-30 on a Dacor oven means the PCB sensor is open or short while the oven operates. Restart, cut power for at least 30 seconds and reconnect, then book a technician if the sensor code reappears.
The Heritage wall oven manual lists three owner causes for an oven that will not heat: a wrong temperature setting, a delayed start left on, and a meat probe still plugged in when you broil. Check those in that order, then look at the display for a C- code.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.