What it means
C-30 on a Dacor oven means the PCB sensor is open or short while the oven operates. Restart, cut power for at least 30 seconds and reconnect, then book a technician if the sensor code reappears.
Dacor oven C-30 / Control board sensor
C-30 on a Dacor oven means the PCB sensor is open or short while the oven operates. Restart, cut power for at least 30 seconds and reconnect, then book a technician if the sensor code reappears.
Also shown as C-30
C-30 on a Dacor oven means the PCB sensor is open or short while the oven operates. Restart, cut power for at least 30 seconds and reconnect, then book a technician if the sensor code reappears.
Press OFF, or turn the burner knob to Off on Transitional ranges, then restart the oven.
C-30 returns after a restart and a 30-second power cut.
Your Dacor tick-list / held on this device

Press OFF, or turn the burner knob to Off on Transitional ranges, then restart the oven.

If C-30 persists, disconnect all power for at least 30 seconds, then reconnect.

Repeated restarts will not fix a sensor circuit problem.

Give us the code C-30 and the model number when you book so the visit can be planned.
Tell us the model and which checks you have done, then open your request from here.
Book a visit
This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
The sensor on the printed circuit board, the control board, is open or short. The Modernist wall oven prints the open and short rows separately.
Read the supporting manualC-31 means the PCB temperature is abnormally high and calls for service only. C-30 is the board sensor circuit with a reset ladder.
Read the supporting manualNo. The Sub PCB sensor is C-22.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 112177 Rev B / DG68-00920A-00 / p.64 (two rows: open / short)
Manufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DG68-01458A-00, 2023-01-17 (EN+ES+FR) / p.103
Manufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DG68-01105E-00, 2020-07-06 (EN+ES+FR) / p.55
Manufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 115113 Rev A / p.71 (either open or short)
Printed in all four guides. Wall oven, T30 and T36 print two rows, the 48/36-inch range one. The solution cell is shared with C-23 and, depending on the guide, with other codes.
No. A board sensor that cannot be read can upset temperature control.
At least 30 seconds, per the guides, with the breaker off, before you reconnect power and start the oven again.
No. The guides give only the restart and power steps, and nothing involving the clock or the timer.
When C-30 returns after a restart and a 30-second power cut.
Dacor codes, symptoms, parts, repairs
C-31 on a Dacor oven means the PCB temperature rose abnormally high. The only action printed is to call for service, so turn the oven off and book a visit.
The Heritage wall oven manual lists three owner causes for an oven that will not heat: a wrong temperature setting, a delayed start left on, and a meat probe still plugged in when you broil. Check those in that order, then look at the display for a C- code.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.