What it means
C-F0 on a Dacor oven means communication between the Main and Sub PBA, the circuit boards, was interrupted. Restart, cut all power for 30 seconds, and call us if the board code reappears.
Dacor oven C-F0 / Communication
C-F0 on a Dacor oven means communication between the Main and Sub PBA, the circuit boards, was interrupted. Restart, cut all power for 30 seconds, and call us if the board code reappears.
Also shown as C-F0
C-F0 on a Dacor oven means communication between the Main and Sub PBA, the circuit boards, was interrupted. Restart, cut all power for 30 seconds, and call us if the board code reappears.
Turn the oven off at the controls and start it again to see whether the board code clears.
C-F0 returns after a restart and a 30-second power cut.
Your Dacor tick-list / held on this device

Turn the oven off at the controls and start it again to see whether the board code clears.

If C-F0 persists, disconnect all power for at least 30 seconds and reconnect.

The boards sit behind panels. Leave them alone.

Give us the code C-F0 and the model number when you book so the visit can be planned.
Tell us the model and which checks you have done, then open your request from here.
Book a visit
This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
The Main board and the Sub board lost communication. PBA is the guide's term for the circuit board assembly.
Read the supporting manualC-F2 is the link between the Main board and the Touch control panel.
Read the supporting manualNo. The cooktop F0 is a similar main and sub PCB failure on another appliance, with a POWER restart remedy.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 112177 Rev B / DG68-00920A-00 / p.64
Manufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DG68-01458A-00, 2023-01-17 (EN+ES+FR) / p.102
Manufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DG68-01105E-00, 2020-07-06 (EN+ES+FR) / p.54
Manufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 115113 Rev A / p.71
Printed in the Modernist wall oven, both Transitional ranges and the Modernist 48/36-inch range. Shares one solution with C-d1, C-F2 and C-20.
The guides do not say. A restart may clear it, but a repeat means a board link problem.
No. That is a separate microwave code for an internal communications failure, with an unplug-and-call remedy.
At least 30 seconds, per the guides, with all power disconnected at the breaker before you reconnect.
Book a visit when C-F0 returns after the restart and the power cut of at least 30 seconds.
Dacor codes, symptoms, parts, repairs
C-F2 on a Dacor oven means communication between the Main board and the Touch control panel was interrupted. Restart and cut power for half a minute; if the panel code is still there, call us.
The Heritage wall oven manual lists three owner causes for an oven that will not heat: a wrong temperature setting, a delayed start left on, and a meat probe still plugged in when you broil. Check those in that order, then look at the display for a C- code.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.