What it means
C-10 on a Dacor DMO30U970SS microwave means the gas sensor is open or shorted. The manual says to unplug the oven, and we do the rest. Unplug it, stop using the sensor cook buttons and book a visit.
Dacor microwave C-10 / Gas sensor
C-10 on a Dacor DMO30U970SS microwave means the gas sensor is open or shorted. The manual says to unplug the oven, and we do the rest. Unplug it, stop using the sensor cook buttons and book a visit.
Also shown as C-10
C-10 on a Dacor DMO30U970SS microwave means the gas sensor is open or shorted. The manual says to unplug the oven, and we do the rest. Unplug it, stop using the sensor cook buttons and book a visit.
The manual says to unplug the power cord of the oven first.
C-10 shows.
Your Dacor tick-list / held on this device

The manual says to unplug the power cord of the oven first. For an over-the-range unit, you may need to switch the breaker off instead.

Until the oven has been checked, cook by time and power level rather than the sensor buttons. This is our precaution, not a manual step.

The sensor sits inside the oven. Opening a microwave exposes high voltage parts, so do not try.
Tell us the code C-10, the model and whether it appeared during Sensor Cook.
Tell us the model and which checks you have done, then open your request from here.
Book a visit
This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.

Component reference
A Dacor microwave sensor picks up the moisture and humidity that rises from heating food, then sets time and power for you.
Read the definitionThe table says the gas sensor is open or shorted. In both cases the sensor circuit is not reading properly.
Read the supporting manualThe manual does not say. The Sensor Cook chapter describes preset foods that cook by sensing, so we link it only loosely and say so.
Read the supporting manualThe manual does not say. The safe step is to unplug it and leave it until checked, since the table asks for exactly that.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
DE68-04568E-00, 2023-04-13 / PDF p.39 (English; Appendix, Information codes)
For C-10: the Dacor slim over-the-range microwave DMO30U970SS. Source is the Information codes table in the appendix of its user manual; the other Dacor microwaves print no such table.
No. C-F0 is an internal communications failure. C-10 is the gas sensor circuit, open or shorted.
The manual tells you to unplug and then contact service. It does not offer a reset as a fix.
The manual lists C-10 as a sensor circuit inside the microwave and mentions no gas supply. It describes a sensor that is open or shorted, not a gas leak.
The code C-10, the model and whether you were using Sensor Cook when it appeared.
Dacor codes, symptoms, parts, repairs
C-F0 on a Dacor DMO30U970SS microwave means it sensed an internal communications failure. Unplug the power cord and book a visit; the manual lists no other owner step.
A Dacor slim over-the-range microwave that will not work has a short checklist: power not supplied, the door open or caught on debris, the Child Lock on, or too many devices on one outlet. Check these before anything else.
A Dacor microwave sensor picks up the moisture and humidity that rises from heating food, then sets time and power for you. The manuals ask for a 2-minute pause after plug-in and a dry dish and cavity. The DMO30U970SS table prints C-10 for a GAS sensor that is open or shorted.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.