Start from the symptom

Dacor dishwasher leaking.

The DDW24G9000AP manual covers leaks in its install steps, not its troubleshooting table: check both ends of the water line and the drain connector, and wipe the water leakage sensor. An LC code means shut the water valve and turn off the breaker.

Last reviewed

Water puddle spreading across a wood floor from under a closed stainless dishwasher, a folded towel lying at the edge of the puddle
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Start with safe observations.

Turn off and unplug the appliance before any check you can make yourself. Beware of pooled water and sharp fragments. Never touch a wet plug or live wiring, take off service panels, or go beyond what your model's guide allows.

  1. 1

    Shut off water and power

    If LC shows, close the water supply valve and set the dishwasher breaker to off at the panel. The manual refers the repair to the installer.

  2. 2

    Drain first

    During the install check, holding Start for more than 3 seconds starts draining. Then unplug the dishwasher and close the water valve.

  3. 3

    Inlet valve and fitting

    The inlet valve is the next place to look for water and, if it leaks, reconnect the 90-degree fitting to the hot water line.

  4. 4

    Both ends of the lines

    Look along the water line at both ends and the drain hose connector for water while a cycle runs.

  5. 5

    Water leakage sensor

    After the leak stops, lay the dishwasher down as shown and wipe moisture from the sensor. If LC keeps appearing, it needs service.

When observation becomes a service request.

Leave internal testing to a technician.

Water appears again, or LC returns after the sensor is dry. Leave the supply valve shut and the breaker off until we arrive.

Arrange a diagnostic

Sources and model boundaries.

The Dacor dishwasher leaking guidance is built on these references. Choose the manual for your own model.

  • User Manual, Built-In Dishwasher DDW24G9000AP

Rely on the guide for your precise model. Look at how we research these pages.

Here to help

Good questions.
Clear answers.

Talk to our team
What does LC mean on a Dacor dishwasher?

It is the leakage check. Close the supply valve and switch the dishwasher breaker off; the manual says the installer repairs it.

Can I run it again after a leak?

Not until the leak is traced. Running with water escaping can damage cabinets and floors.

Does the sensor need to dry?

Yes. The install steps have you wipe moisture from the water leakage sensor once the leak has stopped, then restart.

Is there a leak row in the troubleshooting table?

No. Leaks show up only in the install section and the LC code, which is why this page rests on those two.

Let’s take care of it.

See a C-code?
Tell us the number.