What it means
Seeing C0 on the Modernist induction cooktop tells you the top sensor is open. Turn the cooktop off and restart it. If C0 continues, unplug the power cord for 30 seconds or more and reconnect. Book a visit if it still shows.
Dacor cooktop C0 / Sensor
Seeing C0 on the Modernist induction cooktop tells you the top sensor is open. Turn the cooktop off and restart it. If C0 continues, unplug the power cord for 30 seconds or more and reconnect. Book a visit if it still shows.
Also shown as C0
Seeing C0 on the Modernist induction cooktop tells you the top sensor is open. Turn the cooktop off and restart it. If C0 continues, unplug the power cord for 30 seconds or more and reconnect. Book a visit if it still shows.
Turn the cooktop off at the controls, wait a moment and start it again.
C0 continues after a restart and a 30-second power reset.
Your Dacor tick-list / held on this device

Turn the cooktop off at the controls, wait a moment and start it again. This is the first step in the manual.

If C0 continues, unplug the power cord for at least 30 seconds, then reconnect. For a hardwired cooktop, switch the breaker off for that time.

Cookware or a hot pan near the sensor area can mislead you. Clear the surface and let it cool.

If the code remains after the power reset, the sensor circuit needs testing by a technician.
Tell us the model and which checks you have done, then open your request from here.
Book a visit

This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
The manual lists C0 as "the top sensor is open". It is one of three related codes, C0, C1 and C2, that share the same remedy.
Read the supporting manualC0 means the top sensor circuit is open. C1 means the top sensor is short. C2 is the IGBT sensor, open. The remedy is the same for all three.
Read the supporting manualThen the cooktop recovered. If C0 returns on later days, mention it when you book, because an intermittent open sensor is still a sensor issue.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 113935 Rev. A / DG68-00899A-00 (2017-03-16) / PDF p.63 (Information codes)
For C0: the Modernist induction cooktops (DTI30 and DTI36 series). Source is the Information codes table in the troubleshooting chapter of their user manual; other Dacor cooktops are not covered.
The manual treats it as an information code, with a restart and a power reset as the remedy. It gives no safety warning for C0.
The manual says 30 seconds or more before reconnecting the cord.
Cleaning is good practice, but the manual does not link C0 to spills. It names the sensor itself.
When C0 continues after a restart and a full power reset of 30 seconds or more.
Dacor codes, symptoms, parts, repairs
The top sensor is short whenever C1 appears on this Modernist induction cooktop. Turn the cooktop off and restart it, then unplug the cord for 30 seconds or more if it continues. Book a visit if C1 still shows.
A Dacor Modernist induction cooktop that stays off may simply be starting up: the touchscreen takes about a minute to boot. After that, the chart points to the fuse or breaker, then to burner controls set wrongly.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.