What it means
The top sensor is short whenever C1 appears on this Modernist induction cooktop. Turn the cooktop off and restart it, then unplug the cord for 30 seconds or more if it continues. Book a visit if C1 still shows.
Dacor cooktop C1 / Sensor
The top sensor is short whenever C1 appears on this Modernist induction cooktop. Turn the cooktop off and restart it, then unplug the cord for 30 seconds or more if it continues. Book a visit if C1 still shows.
Also shown as C1
The top sensor is short whenever C1 appears on this Modernist induction cooktop. Turn the cooktop off and restart it, then unplug the cord for 30 seconds or more if it continues. Book a visit if C1 still shows.
Switch the cooktop off at the controls and start it again to see whether C1 clears.
C1 continues after a restart and a 30-second power reset.
Your Dacor tick-list / held on this device

Switch the cooktop off at the controls and start it again to see whether C1 clears.

If it continues, unplug the cord or switch the breaker off for at least 30 seconds, then restore power.

Wipe up any spills near the controls with a dry cloth. The manual does not link them to C1, but moisture is never helpful.

A shorted sensor needs testing with a meter. Give us the code and the model number.
Tell us the model and which checks you have done, then open your request from here.
Book a visit

This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
The table says the top sensor is short. That is the opposite electrical condition to C0, where the same sensor is open.
Read the supporting manualThe manual only says the sensor is short. We do not describe the circuit further, because the document does not.
Read the supporting manualThe manual gives no workaround. Stop using it until the code has been cleared or the cooktop has been checked.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 113935 Rev. A / DG68-00899A-00 (2017-03-16) / PDF p.63 (Information codes)
For C1: the Modernist induction cooktops (DTI30 and DTI36 series). Source is the Information codes table in the troubleshooting chapter of their user manual; other Dacor cooktops are not covered.
No. C0 is open and C1 is short, but both concern the top sensor and share the same restart and power reset steps.
The manual does not say. The cooktop restarts after power returns.
The manual does not state a cause for C1 beyond the shorted sensor.
The code C1, whether a restart cleared it and how long you left the power off.
Dacor codes, symptoms, parts, repairs
Seeing C0 on the Modernist induction cooktop tells you the top sensor is open. Turn the cooktop off and restart it. If C0 continues, unplug the power cord for 30 seconds or more and reconnect. Book a visit if it still shows.
A Dacor Modernist induction cooktop that stays off may simply be starting up: the touchscreen takes about a minute to boot. After that, the chart points to the fuse or breaker, then to burner controls set wrongly.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.