What it means
Your Modernist induction cooktop reports an open IGBT sensor with the code C2. Turn the cooktop off and restart it, then unplug the cord for 30 seconds or more if it continues. Book a visit if C2 still shows.
Dacor cooktop C2 / Sensor
Your Modernist induction cooktop reports an open IGBT sensor with the code C2. Turn the cooktop off and restart it, then unplug the cord for 30 seconds or more if it continues. Book a visit if C2 still shows.
Also shown as C2
Your Modernist induction cooktop reports an open IGBT sensor with the code C2. Turn the cooktop off and restart it, then unplug the cord for 30 seconds or more if it continues. Book a visit if C2 still shows.
Turn it off at the controls and back on.
C2 continues after a restart and a 30-second power reset.
Your Dacor tick-list / held on this device

Turn it off at the controls and back on. A momentary glitch may clear.

If C2 stays, unplug the cord for 30 seconds or more, or switch the breaker off, then reconnect.

The IGBT is a power electronics part inside the unit. It is not an owner job.

Give us the code C2 and the model number from the rating label.
Tell us the model and which checks you have done, then open your request from here.
Book a visit

This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.
The table lists C2 as "the IGBT sensor is open". The IGBT is a power switching part of the induction electronics.
Read the supporting manualC0 and C1 concern the top sensor, open and short. C2 concerns a different sensor, on the IGBT. All three share one remedy.
Read the supporting manualIt may. If it does not, the manual says to unplug for 30 seconds and then contact a service center, and we offer a visit instead.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 113935 Rev. A / DG68-00899A-00 (2017-03-16) / PDF p.63 (Information codes)
For C2: the Modernist induction cooktops (DTI30 and DTI36 series). Source is the Information codes table in the troubleshooting chapter of their user manual; other Dacor cooktops are not covered.
It is an electronic switching part inside induction cooktops. The manual uses the name without explaining it, and we stay with the printed wording.
No. Stop using the cooktop until it has been checked, because the manual lists C2 as an information code with a service remedy.
The manual does not link C2 to cookware. It names the IGBT sensor circuit, so moving pans around will not change this code.
The code, the model and whether a 30-second power reset changed anything.
Dacor codes, symptoms, parts, repairs
Seeing C0 on the Modernist induction cooktop tells you the top sensor is open. Turn the cooktop off and restart it. If C0 continues, unplug the power cord for 30 seconds or more and reconnect. Book a visit if it still shows.
A Dacor Modernist induction cooktop that stays off may simply be starting up: the touchscreen takes about a minute to boot. After that, the chart points to the fuse or breaker, then to burner controls set wrongly.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.