What it means
Communication between the main and sub PCBs has failed when F0 shows on the Modernist induction cooktop. Restart with the POWER button, then disconnect power for more than 30 seconds if it continues. Book a visit if it stays.
Dacor cooktop F0 / Communication
Communication between the main and sub PCBs has failed when F0 shows on the Modernist induction cooktop. Restart with the POWER button, then disconnect power for more than 30 seconds if it continues. Book a visit if it stays.
Also shown as F0
Communication between the main and sub PCBs has failed when F0 shows on the Modernist induction cooktop. Restart with the POWER button, then disconnect power for more than 30 seconds if it continues. Book a visit if it stays.
Use the POWER button first, as the manual says.
F0 stays after a POWER restart and a power reset of more than 30 seconds.
Your Dacor tick-list / held on this device

Use the POWER button first, as the manual says.

If F0 continues, cut power for more than 30 seconds (unplug or breaker off), then restart the cooktop.

Make sure no water has reached the control area. The manual does not name this as a cause, but wet electronics can misbehave.

A failed link between boards needs a technician. Quote F0 and the model number.
Tell us the model and which checks you have done, then open your request from here.
Book a visit
This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.

Component reference
The cooktop main and sub boards are two circuit boards that work together inside the Modernist induction cooktop, with an EEPROM memory chip alongside.
Read the definitionCommunication between the main printed circuit board and the sub board failed. The two boards share information, and the link broke.
Read the supporting manualF0 is main to sub board. F1 is communication with the EEPROM, the memory chip. F2 is communication with the touch-enabled IC. Their remedies are identical.
Read the supporting manualA restart and a power reset of over 30 seconds are the only owner steps in the manual. A repeat means the cause is still there.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 113935 Rev. A / DG68-00899A-00 (2017-03-16) / PDF p.63 (Information codes)
For F0: the Modernist induction cooktops (DTI30 and DTI36 series). Source is the Information codes table in the troubleshooting chapter of their user manual; other Dacor cooktops are not covered.
No. It is an information code. A restart or power reset may clear it.
More than 30 seconds, per the manual. Unplug the cord or switch the breaker off for that time, then restart the cooktop.
Printed circuit boards, the electronic control boards inside the cooktop.
The code F0, the steps you tried and whether it appears at start-up or during cooking.
Dacor codes, symptoms, parts, repairs
F1 is how the Modernist induction cooktop reports that communication with the EEPROM failed. Restart with the POWER button, then disconnect power for more than 30 seconds if it continues. Book a visit if it stays.
A Dacor Modernist induction cooktop that stays off may simply be starting up: the touchscreen takes about a minute to boot. After that, the chart points to the fuse or breaker, then to burner controls set wrongly.
The cooktop main and sub boards are two circuit boards that work together inside the Modernist induction cooktop, with an EEPROM memory chip alongside. The manual prints F0 when the two boards lose contact and F1 when the EEPROM cannot be reached. Restart with POWER, wait with power off, then book a visit.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.