What it means
The code F2 means the Modernist induction cooktop lost communication with its touch-enabled IC. Restart with the POWER button, then disconnect power for more than 30 seconds if it continues. Book a visit if it stays.
Dacor cooktop F2 / Communication
The code F2 means the Modernist induction cooktop lost communication with its touch-enabled IC. Restart with the POWER button, then disconnect power for more than 30 seconds if it continues. Book a visit if it stays.
Also shown as F2
The code F2 means the Modernist induction cooktop lost communication with its touch-enabled IC. Restart with the POWER button, then disconnect power for more than 30 seconds if it continues. Book a visit if it stays.
Press the POWER button to restart and see if the touch controls recover.
F2 stays after a POWER restart and a power reset of more than 30 seconds.
Your Dacor tick-list / held on this device

Press the POWER button to restart and see if the touch controls recover.

If F2 persists, cut power for more than 30 seconds and restart.

The touch IC senses your fingers. Dry the control area so water does not interfere.

A failed touch IC link points to the control panel and needs a technician.
Tell us the model and which checks you have done, then open your request from here.
Book a visit
This drawing is schematic, since the inside of a Dacor changes from model to model. Press an outlined part for its photo and the check that goes with it.

Component reference
A 7-inch touch-enabled screen with POWER and LOCK keys runs the Modernist induction cooktop.
Read the definitionThe cooktop lost communication with the touch-enabled IC, the chip that reads the touch controls.
Read the supporting manuald0 is a key pressed for more than 8 seconds. F2 is a failed link with the touch IC. Both involve the touch controls, but they are different codes.
Read the supporting manualTry the POWER restart and the power reset. If the panel stays dead, book a visit.
Read the supporting manualManufacturer document
Dacor (Dacor-branded document hosted on image-us.samsung.com)
Part No. 113935 Rev. A / DG68-00899A-00 (2017-03-16) / PDF p.63 (Information codes)
For F2: the Modernist induction cooktops (DTI30 and DTI36 series). Source is the Information codes table in the troubleshooting chapter of their user manual; other Dacor cooktops are not covered.
The manual does not say so. F2 is an electronic communication code.
The manual does not list it, but it does for d0, so keep the panel dry anyway.
On the Dacor microwave C-F2 means a touch button malfunctioned. Here F2 is the touch IC link of the cooktop.
The code, the restart steps and whether the touch controls respond.
Dacor codes, symptoms, parts, repairs
Communication between the main and sub PCBs has failed when F0 shows on the Modernist induction cooktop. Restart with the POWER button, then disconnect power for more than 30 seconds if it continues. Book a visit if it stays.
A Dacor Modernist induction cooktop that stays off may simply be starting up: the touchscreen takes about a minute to boot. After that, the chart points to the fuse or breaker, then to burner controls set wrongly.
A 7-inch touch-enabled screen with POWER and LOCK keys runs the Modernist induction cooktop. Its manual ties a damp or covered key to code d0, a key held over 8 seconds. Dry the panel, clear the glass and restart with POWER before booking a visit.
Book a diagnostic for your model at the appliance itself.
Office details and the access notes to pass on.